Custom Pro 5mm Round Toe Neoprene Boots

5 mm Round Toe Pro Series

This boot continues to improve!

Meticulous attention to detail, extensive testing, and thoughtful refinements have gone into creating this boot. The Custom Pro distinct Full Wrap arch strap secures your foot inside the boot, enhancing the response between your foot movement and the board interaction. Additionally, the custom heat-moulding fitting process ensures better responsiveness in every turn.

• Tatex-Print heel for enhanced durability and easy on-off
• Double reinforced, extra-strong heel-loop for lasting durability
• Includes Heat booster socks
• Heat mouldable custom fit
• Seamless 6-5mm Thermo-Form for greater comfort and warmth
• Flexible 1mm vulcanised rubber sole
• Quick-dry lining
• 4mm EZ-O cuff seal for added water barrier protection

Heat Moulding Guide

1. Bring water to a boil (you will need about 3 cups of boiling water per boot.)
2. As the water heats, roll down the cuffs of your Solite boots and place them in a sink.
3. Wear your Solite Heat Booster socks if you intend to use them inside your boots.
4. Once the water reaches a full boil, carefully pour it into your Solite boots (in the sink), filling each to just below the seam where the neoprene upper joins the sole. Refer to photo.
5. Allow 5 minutes for the boiling water to soften the sole material.
6. After 5 minutes, cautiously pour out the hot water from your Solite boot (handling one boot at a time) and swiftly rinse the inside of the boot with cold water to reduce the surface temperature to a comfortable level. Test with your hand as you will need to insert your foot when it is as warm as comfortably possible.
7. Insert your foot into your Solite boot while wearing the Heat Booster sock if you intend to use the socks regularly. Ensure your big-toe is comfortably positioned in the toe cavity and your heel sits snugly in the heel pocket.
8. Repeat Steps 6 and 7 for the other boot.
9. Fasten boot ankle straps if applicable.
10. Walk around in your Solite boots for the next 10-15 minutes to allow the boots to mould comfortably to your feet as they cool.
11. Once your Solite Boots have cooled to room temperature, the moulding process is complete.
12. Should the fit be unsatisfactory, you can re-mould your Solite boots by repeating the same steps outlined above. Your Solite boots should feel entirely comfortable, akin to being an extension of your foot.