Guide to Fitting Skateboard Bushings

Looking for guidance on fitting your skate bushings? You've arrived at the correct location. In this video, we'll demonstrate how to install skateboard bushings in just a few straightforward steps:

Required tool: skate tool.

1. To start, slide the larger bottom washer onto the bolt.
2. Then, position the bottom barrel-shaped bushing onto the washer.
3. Set the hanger on top of the bushing.
4. Afterwards, place the cone-shaped bushing onto the bolt.
5. Then, slide the smaller washer onto the bushing.
6. Use your fingers to screw on the lock nut.
7. Securely tighten the lock nut with a skate tool.
8. Ensure the rubber part of the nut catches the bolts properly.

Your bushings are now successfully installed!