Guide to Fitting EST Bindings

This video will guide you through the process of fitting EST bindings onto your snowboard. Burton EST bindings utilise the channel system, a prevalent snowboard binding system in use today:

1. Begin by ensuring you possess an EST binding. It should include a channel insert.
2. Then, lift off the rubber cover from the channel with a flat screwdriver.
3. Place the EST mounting hardware into the channel.
4. Next, open up your binding.
5. Remember that there is a recommended mounting position on the board.
6. Take your binding and line it up with the hardware you have just inserted.
7. Press down on the channel insert to secure it within the channel.
8. Using a Phillips screwdriver, take the provided screws and start attaching them to the board. Leave them slightly loose for now.
9. The binding should still be movable at this stage.
10. Adjust the binding according to the markers on the board.
11. You can now fully tighten the screws and put the rubber cover back on.

Your bindings are now fitted!